Storing Measurement Data
After completing a measurement and before taking another
measurement, data can be stored to an active project. Refer to
Chapter 7: for instructions on creating and selecting the active
project.
If a project is active and the Auto-Store function (see page 8–12)
is enabled, press ESC or ENTER/START to continue. Foreach
measurement, the gauge can store a location description of up
to 12 characters, as well as a note of up to 15 characters. Follow
the prompts to enter location information and/or a note.
If a project is active but the Auto-Store function is not enabled:
Press STORE to store the results. Follow the prompts to
enter location information and/or notes. For more
information on storing results manually, see page 8–14.
Press ESC to return to the Ready screen without storing
the results. Note that, until another measurement has
been taken, the results can be recalled (as described
below) and stored later.
To Next Page
Loading...
Need help?
General
