TSI Instruments 3022A - Page 14

xii Model 3022A Condensation Particle Counter
10 Applications.......................................................................10-1
Clean Air.............................................................................10-1
Using the CPC With a Multiplexer/Processor ......................10-1
Testing Filter Efficiency.......................................................10-2
Using the CPC With a Diffusion Battery ..............................10-2
Differential Mobility Particle Sizer........................................10-3
Appendixes
A References ...........................................................................A-1
B Specifications....................................................................B-1
C Technical Papers ...............................................................C-1
E Calibration and Data Sheets .............................................D-1
F Software Disk.....................................................................E-1
Figures
1 Advisory Labels: (a) identification label (on the back panel); (b)
warning label (on the optics housing) ...............................viii
1-1 TSI Model 3022A Condensation Particle Counter................1-1
2-1 Power Entry, Fuse, and Voltage Module..............................2-3
2-2 Orientation of the Voltage Selector Card .............................2-3
2-3 North American–Fusing Arrangement .................................2-5
2-4 European–Fusing Arrangement ..........................................2-5
2-5 Fuse Block/Cover Assembly ...............................................2-5
2-6 Mounting the Bottle Bracket: (a) Bottle Bracket; (b) Screw,
8-32 ×
3
/8 Phillips Pan-head Lockwasher, #8 Internal
Tooth; (c) CPC Back Panel ...............................................2-6
2-7 Removing the Front Inlet Tube; (a) Pull Inlet Tube Out;
(b) Loosen Swagelok Nuts, 2 Places .................................2-8
2-8a Back Inlet Option for Positioning the Inlet Tube..................2-9
2-8b Front Inlet Option for Positioning the Inlet Tube ...............2-10
2-8c Side Inlet Option for Positioning the Inlet Tube .................2-11
2-8d Side Inlet Option with the 2.8-in. Inlet Tube .....................2-12
3-1 CPC Front Panel .................................................................3-1