Manual History
ii
The following is a manual history of the Model 3022A Condensation
Particle Counter Instruction Manual (Part Number 1933763).
Revision Date Revision Date
Preliminary October 1992 E November 1996
Final November 1992 F March 1998
A January 1993
September 1998
B December 1993 G July 2000
C June 1994 H July 18, 2000
D May 1996 I July 2002
! The Model 3022A Condensation Particle
Counter instruction manual (P/N
1933763) was originally published as a
Model 3022 Condensation Particle Counter
(P/N 1933022) in September 1988.
Changes have been made throughout the
manual to reflect the model number and
engineering changes.
! Revision A reflects changes to the table in
Chapter 4, a new safety label, inclusion of
ampere ratings (Figure 3-2 and
“Specifications”), and some minor
corrections throughout the manual.
! Revision B includes a revision to Table 2-
1, changes amount of particles from 0.01
to .007 on page 1-1, revises the Customer
Service telephone number, and updates
drawing 9060266 in Appendix D to
Revision F.
! Revision C adds Figure 7-1 showing the
setup for photometric calibration mode,
revises Figure 9-6, and revises schematic
9060265.
! Revision D updates TSI’s “Limitation of
Warranty and Liability” on page iii.
! Revision E adds European Community
“CE Mark” standards, revisions to Chapter
2, “Changing the Line Voltage
Configuration” and “Changing Fuses,”
updates drawing 9060266 in Appendix D
to Revision I, and minor changes were
made to rest of manual.
! Revision F revises minimum particle size
from .008 µm to .007 µm in Table B-1.
! In September 1998, TSI’s area code was
changed from 612 to 651.
! In Revision G, the fuse rating in Table B-1
was corrected to read 100/120V ~
2.0A/250V.
! In Revision H, TSI’s Limitation of Warranty
and Liability was updated.
! In Revision I, TSI’s phone numbers and
address were updated and reference to
CPCount Software was changed to refer to
Aerosol Instrument Manager Software for
CPC and EAD. Appendix D was removed.
To Next Page
Loading...
Need help?
General
