BL20 - Communication in CANopen
D301087 0308 - BL20 CANopen4-276
The following table shows the meaning of the parameter bits:
Byte Design. Status
Comment
Byte 1 Disable
Cfg
Automatic SWIRE configuration
Disabling of the acceptance of the physically present configu-
ration as ACTUAL configuration on manual pushbutton actua-
tion.
0 A Inactive The physically present configuration
of the SWIRE bus is only accepted as
the ACTUAL configuration by
pressing the CFG button. The
comparison with the SET configura-
tion is then carried out
1 Active The physically present configuration
is automatically accepted as the
ACTUAL configuration and then
compared with the SET configuration.
Configu-
ration
PLC configuration check
The configuration check parameter enables a comparison of
the set and actual configuration based on the device ID.
0
A Inactive Configuration check based on device
ID. Only SWIRE slaves with a device
ID completely matching the set
configuration are accepted on the bus
1 Active All slaves are mapped in 4Bit INPUT/
4Bit OUTPUT without checking the
device ID.
To Next Page
Loading...
