D301087 0308 - BL20 CANopen 6-17
Extending an Existing Station
6
Extending an Existing Station
Once alterations have been made to the order of the modules on the
BL20 station, the new configuration must be saved to the ”actual
configuration memory” of the BL20 gateway. This is done by either
pressing the SET button between the two decimal rotary coding
switches (see chapter 2) or by making the appropriate settings in the
configuration software (see chapter 3).
Attention
Please note that extensions to the station (mounting further mod-
ules) should be carried out only when the station is off-circuit.
To Next Page
Loading...
