D301087 0308 - BL20 CANopen 7-17
Two-Pole Shield Connection
7
Two-Pole Shield Connection
The 2-pole shield connection can be used to connect signal-cable
shielding to the base modules of analog input and output modules.
A special tension-clamp operating tool (BL20-ZBW5-2) is required
to mount the shield connection onto the base module.
The following cable diameters are permissible for the shield connec-
tion:
Diameter of the shielding braid: max. 4.9 mm / 0.19 inch
Outer diameter of the cable: max. 6.5 mm / 0.26 inch
Figure 17:
Two-pole shield
connection for an-
alog modules
To Next Page
Loading...
