Page 10
3 Technical Data
3.1 Directives and Standards
Every autoclave meets the provisions of the following Directives and is in
compliance with the following Standards:
Quality Management System
Environmental Management System
General requirements for the competence of testing and
calibration autoclaves
Section I and section VIII. Div. I
Special Equipment Licensing Office
IEC 61010-1 / UL 61010-1:
Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 1:
General requirements
Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 2-040:
Requirements for sterilizers and washer-disinfectors
used to treat medical materials
EMC Requirements for Electrical Equipment
To Next Page