Page 84
4. To release the door locking at the end of operation, press the UP key.
The same applies at power up after fail. For MD models, rotate the
handle counter clockwise to pull out the locking arms handle from the
retaining brackets.
5. Wear heat-resistant gloves or use the tray handle to remove the load
from the autoclave.
6. On completion of the cycle, the load shall be visual inspected to
ascertain that the load is dry, and that the color of the sterilization
indicators turned to the required color.
7. At the end of each working day close the main water valve.
10.11 Start Cycle by Clock mode
1. This mode enables the operator to define the time of the beginning of
the cycle. The maximum possible delay is 24 hours.
To Next Page
Loading...
