Page 80
10.4 Safety
Protective equipment and clothes and other safety instructions should
be implemented in accordance with local and national regulations
and/or rules!
For proper sterilization - Do not overload the chamber. Only
autoclavable products shall be used; please refer to the manufacturer
instructions for sterilization of unknown materials or instruments.
10.5 Loading
Correct loading of the autoclave is essential to successful sterilizing
for several reasons. Efficient air removal from the chamber and the
load will permit total steam penetration and saturation and allow
proper drainage of condensate. Additionally, correct loading will
reduce damage to packs and their contents and maximize efficient
use of the sterilizer.
For detailed loading instructions, see sec. 9 (Preparation before
sterilization)
10.6 Selecting the Program
1. Select the program.
▪ UP key: next program.
▪ DOWN key: previous program.
2. Make sure Verify that you chose the required program.
3. If the autoclave is equipped with a printer verify that a paper roll is
inserted in the printer. If not - insert as described in sec. 8.2.
Attention:
Selecting a program is possible only when the door is open.
To Next Page
Loading...
