Page 2
5.8
Program 8: Bio Hazard 2 (BH, bio-hazard models only) ................. 39
5.9
Program 9: Bio Hazard Liquids (BH, bio-hazard models only) ........ 40
5.10
Program 10: Vacuum Test (PV, pre-vacuum models only) ............. 42
5.11
Program 11: Warm-Up ................................................................... 43
5.12
Program 12: Isothermal .................................................................. 44
5.13
Program 13: Air Mixture ................................................................. 45
5.14
Program 14: Glass Test ................................................................. 46
5.15
Program 15: Durham ...................................................................... 48
6
Screens .................................................................................................. 50
6.1
Screens following a completely successful cycle – "Cycle Ended".. 50
6.2
Screens following aborted cycles after complete sterilization stage 51
6.3
Screens following a fail cycle: ........................................................ 51
7
Checking and Changing Parameters and other data .............................. 53
7.1
Browsing through the menus .......................................................... 53
7.2
Changing a Parameter ................................................................... 54
7.3
Quick options screen ...................................................................... 56
7.4
Logging in and entering the Main menu.......................................... 61
7.5
Changing parameters ..................................................................... 62
7.6
System Parameters ........................................................................ 63
7.7
Maintenance .................................................................................. 64
7.8
Cycle parameters ........................................................................... 66
8
Printer .................................................................................................... 68
8.1
Printer Output................................................................................. 68
8.2
Printer Handling ............................................................................. 71
8.3
Treating the thermal papers: .......................................................... 72
9
Preparation before Sterilization .............................................................. 74
9.1
Instruments .................................................................................... 74
9.2
Tubing ............................................................................................ 76
9.3
Sterilization of Liquids .................................................................... 76
9.4
Filling the Water Reservoir ............................................................. 77
10
Operating Instructions ............................................................................ 78
10.1
Turning on the autoclave ................................................................ 78
10.2
Opening the door – MD models (mechanical door) ......................... 78
10.3
Opening the door – D models (automatic door) .............................. 79
10.4
Safety ............................................................................................ 80
10.5
Loading .......................................................................................... 80
10.6
Selecting the Program .................................................................... 80
10.7
Closing the door – MD models (mechanical door) .......................... 81
10.8
Closing and locking the door – D models (automatic door) ............. 81
10.9
Starting cycle ................................................................................. 83
To Next Page
Loading...
