SARA-R4/N4 series-AT Commands Manual
UBX-17003787 - R09

10V24 control and V25ter
Page 104 of 307
10.13î™–î™–î™–î™–Response formatting character S4
S4
SARA-R404M SARA-R410M-01B SARA-R410M-02B SARA-R410M-52B SARA-R412MModules
SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error referenceAttributes
partial No Profile No - +CME Error
10.13.1î™–î™–î™–î™–Description
Sets a value representing the decimal IRA5 value of the character generated by the DCE as part of the header,
trailer and terminator for result codes and information text, along with the S3 setting.
10.13.2î™–î™–î™–î™–Syntax
Type Syntax Response Example
Set ATS4=<value> OK ATS4=10
OK
Read ATS4? <value>
OK
010
OK
10.13.3î™–î™–î™–î™–Defined values
Parameter Type Description
<value> Number Range 0 to 127. The answer to the read command is in "xxx" format. The default and
the factory-programmed value is 10 (line feed (LF, IRA5 0/10)).
10.14î™–î™–î™–î™–Command line editing character S5
S5
SARA-R404M SARA-R410M-01B SARA-R410M-02B SARA-R410M-52B SARA-R412MModules
SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error referenceAttributes
partial No Profile No - +CME Error
10.14.1î™–î™–î™–î™–Description
Sets a value representing the decimal IRA5 character recognized by the DCE as a request to delete from the
command line the immediately preceding character.
10.14.2î™–î™–î™–î™–Syntax
Type Syntax Response Example
Set ATS5=<value> OK ATS5=8
OK
Read ATS5? <value>
OK
008
OK
10.14.3î™–î™–î™–î™–Defined values
Parameter Type Description
<value> Number Range 0 to 127. The answer to the read command is in "xxx" format. The default and
the factory-programmed value is 8 (ASCII backspace (BS, IRA5 0/8)).
To Next Page
Loading...
Need help?
General
