Ublox SARA-R4 Series - PDP IP Configuration When Roaming +UDCONF=75; Enable;Disable Data When Roaming +UDCONF=76

SARA-R4/N4 series-AT Commands Manual
UBX-17003787 - R09

13Packet switched data services
Page 142 of 307
• The <username> and <password> parameters must be set to an empty string if the authentication type
is not set (<auth_type>=0).
SARA-R4 / SARA-N4
• <auth_type>=3 is not supported.
13.16PDP IP configuration when roaming +UDCONF=75
+UDCONF=75
SARA-R410M-02B SARA-R410M-52B SARA-R412MModules
SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error referenceAttributes
full Yes NVM No - +CME Error
13.16.1Description
Configures the PDP IP when roaming. When set, the PDP IP can be limited to IPv4, IPv6, or IPv4v6 when roaming
on a network.
The configuration will be effective at the next power on.
Only one PDP profile can be set using this command.
13.16.2Syntax
Type Syntax Response Example
Set AT+UDCONF=75,<cid>,<PDP_IP_
conf>
OK AT+UDCONF=75,1,0
OK
Read AT+UDCONF=75 +UDCONF: 75,<cid>,<PDP_IP_conf>
OK
AT+UDCONF=75
+UDCONF: 75,1,0
OK
13.16.3Defined values
Parameter Type Description
<cid> Number See <cid>.
<PDP_IP_conf> Number PDP IP configuration when roaming:
• 0: IP
• 1: IPv6
• 2: IPv4v6
See <PDP_type>.
13.16.4Notes
SARA-R4 / SARA-N4
• Set the <PDP_IP_conf> parameter before to read it.
13.17Enable/Disable data when roaming +UDCONF=76
+UDCONF=76
SARA-R410M-02B SARA-R410M-52B SARA-R412MModules
SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error referenceAttributes
full Yes NVM No - +CME Error
13.17.1Description
Configures the PDP to enable or disable when roaming. When set to disabled, the PDP will not be able to send
data when roaming on a network.