Ublox SARA-R4 Series

SARA-R4/N4 series-AT Commands Manual
UBX-17003787 - R09

9Short Messages Service
Page 91 of 307
Parameter Type Description
<max> Number Maximum number of short messages in the concatenated short message (1-255)
<iei> Number Information Element Identifier, the possible values are the following:
• 0: Concatenated short messages, 8-bit reference number
• 8: Concatenated short messages, 16-bit reference number
<ref> Number Concatenated short message reference number:
• 0-255: Concatenated short messages, 8-bit reference number case
• 0-65535: Concatenated short messages, 16-bit reference number case
<text> String SMS String
<index> Number Storage position
9.21More messages to send +CMMS
+CMMS
SARA-R404M SARA-R410M-01B SARA-R410M-02B SARA-R410M-52B SARA-R412MModules
SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error referenceAttributes
full Yes No No - +CMS Error
9.21.1Description
Controls the continuity of SMS relay protocol link. When enabled, multiple SMS messages can be sent much
faster as link is kept open.
9.21.2Syntax
Type Syntax Response Example
Set AT+CMMS=[<mode>] OK AT+CMMS=2
OK
Read AT+CMMS? +CMMS: <mode>
OK
+CMMS: 2
OK
Test AT+CMMS=? +CMMS: (list of supported
<mode>s)
OK
+CMMS: (0-2)
OK
9.21.3Defined values
Parameter Type Description
<mode> Number
• 0 (default value): disabled
• 1: keep enabled until the time between the response of the latest message send
command (such as +CMGS) and the next send command exceeds 5 s, then close
the link and switch <mode> automatically back to 0
• 2: keep permanently enabled. The link is closed after each send sequence, but
<mode> is not switched back to 0
9.22Sending of originating data via the control plane
+CSODCP
+CSODCP
Modules SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error referenceAttributes
full No No No - +CME Error
9.22.1Description
Transmits data over control plane from a DTE to the network. Data is identified by the local context
identification parameter <cid>. This command causes transmission of an ESM DATA TRANSPORT message
(see the 3GPP TS 24.301 [88] subclause 9.9.4.25).