Ublox SARA-R4 Series - Close Logical Channel +UI2 CC

SARA-R4/N4 series-AT Commands Manual
UBX-17003787 - R09

23I
2
C
Page 246 of 307
23.5.3Defined values
Parameter Type Description
<register_address> Number Device address in HEX format
<nof_bytes_to_read> Number Number of bytes to read from the slave I
2
C register. The range goes from 1 to 100.
<index1>,...,<index_
n>
Number Index of the byte being printed.
<byte_1>,...,<byte_n> Number n-th byte of the data, in hex mode (unquoted, prefixed by 0x).
23.6I
2
C close logical channel +UI2CC
+UI2CC
SARA-R410M-02B SARA-R410M-52B SARA-R412MModules
SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error referenceAttributes
full No No No - +CME Error
23.6.1Description
Closes the I
2
C logical channel being used.
The logical channel must be closed before opening a new one.
23.6.2Syntax
Type Syntax Response Example
Action AT+UI2CC OK AT+UI2CC
OK
Test AT+UI2CC=? OK OK