Ublox SARA-R4 Series - Show PDP Address +CGPADDR; GPRS Event Reporting +CGEREP

SARA-R4/N4 series-AT Commands Manual
UBX-17003787 - R09

13Packet switched data services
Page 133 of 307
13.8Show PDP address +CGPADDR
+CGPADDR
SARA-R404M SARA-R410M-01B SARA-R410M-02B SARA-R410M-52B SARA-R412MModules
SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error referenceAttributes
full Yes No No - +CME Error
13.8.1Description
Returns a list of PDP addresses for the specified context identifiers. Only defined PDP contexts are displayed.
If the <cid> parameter is omitted, the addresses for all defined contexts are returned.
13.8.2Syntax
Type Syntax Response Example
Set AT+CGPADDR=[<cid>[,<cid> [,...]]] +CGPADDR: <cid>,<PDP_addr>
[+CGPADDR: <cid>,<PDP_addr>
[...]]
OK
AT+CGPADDR=1
+CGPADDR: 1,"1.2.3.4"
OK
Test AT+CGPADDR=? +CGPADDR: [(list of defined <cid>s)]
OK
+CGPADDR: 1,3
OK
13.8.3Defined values
Parameter Type Description
<cid> Number See <cid>
<PDP_addr> Number See <PDP_addr>
13.9GPRS event reporting +CGEREP
+CGEREP
SARA-R410M-02B SARA-R410M-52B SARA-R412MModules
SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error referenceAttributes
partial Yes No No - +CME Error
13.9.1Description
Configures sending of URCs from MT to the DTE, in case of certain events occurring during GPRS signalling
between the MT and the network.
13.9.2Syntax
Type Syntax Response Example
Set AT+CGEREP=[<mode>[,<bfr>]] OK AT+CGEREP=1,1
OK
Read AT+CGEREP? +CGEREP: <mode>,<bfr>
OK
+CGEREP: 0,0
OK
Test AT+CGEREP=? +CGEREP: (list of supported
<mode>s),(list of supported <bfr>s)
OK
+CGEREP: (0-2),(0-1)
OK
+CGEV: ME PDN ACT <cid>[,
<reason>[,<cid_other>]]
+CGEV: ME ACT <p_cid>,<cid>,
<event_type>
URC
+CGEV: ME PDN DEACT <cid>
+CGEV: NW CLASS "CC"