Ublox SARA-R4 Series - Page 134

SARA-R4/N4 series-AT Commands Manual
UBX-17003787 - R09

13Packet switched data services
Page 134 of 307
Type Syntax Response Example
+CGEV: ME DEACT <PDP_type>,
<PDP_addr>,[<cid>]
+CGEV: ME DEACT,<p_cid>,<cid>,0
+CGEV: ME DEACT <p_cid>,<cid>,
<event_type>
+CGEV: ME MODIFY <cid>,
<change_reason>,<event_type>
+CGEV: ME DETACH
+CGEV: ME CLASS <class>
+CGEV: NW PDN ACT <cid>[,
<reason>]
+CGEV: NW ACT <p_cid>,<cid>,
<event_type>
+CGEV: NW PDN DEACT <cid>
+CGEV: NW DEACT,<p_cid>,<cid>,0
+CGEV: NW DEACT <p_cid>,<cid>,
<event_type>
+CGEV: NW DEACT <PDP_type>,
<PDP_addr>,[<cid>]
+CGEV: NW MODIFY <cid>,
<change_reason>,<event_type>
+CGEV: NW DETACH
+CGEV: NW CLASS <class>
+CGEV: VZW_SUBS_ACTION_
NORMAL (0) - No restriction to data
traffic
13.9.3Defined values
Parameter Type Description
<mode> Number Controls the processing of URCs specified within this command. Allowed values:
• 0 (default value): buffer URCs in the MT; if the buffer is full the oldest ones will be
discarded
• 1: discard URCs when V.24 link is reserved (online); otherwise forward them directly
to the DTE
• 2: buffer URCs in the MT when link reserved (online) and flush them to the DTE when
the link becomes available; otherwise forward them directly to the DTE
<bfr> Number Controls the effect on buffered codes when <mode> 1 or 2 is entered. Allowed values:
• 0 (default value): MT buffer of URCs defined within this command is cleared when
<mode> 1 or 2 is entered
• 1: MT buffer of URCs defined within this command is flushed to the DTE when
<mode> 1 or 2 is entered (OK is given before flushing the codes)
<cid> Number See <cid>
<reason> Number Indicates whether the reason why the context activation request for PDP type IPv4v6
was not granted:
• 0: IPv4 only allowed
• 1: IPv6 only allowed
• 2: single address bearers only allowed
• 3: single address bearers only allowed and MT initiated context activation for a
second address type bearer was not successful
<cid_other> Number Indicates whether the context identifier allocated by MT for an MT initiated context
of a second address type
<p_cid> Number Numeric parameter that identifies the particular PDP context definition, specified
using +CGDCONT, to which a secondary PDP context definition will be associated
using +CGDSCONT.
This parameter is only locally valid on the interface TE-MT.
<event_type> Number Indicates whether the event is informational or whether the TE has to acknowledge it:
• 0: informational event
• 1: information request: acknowledgement required