Ublox SARA-R4 Series - Timer Trigger Configuration for Direct Link +UDCONF=5

SARA-R4/N4 series-AT Commands Manual
UBX-17003787 - R09

18Internet protocol transport layer
Page 198 of 307
18.18.2Syntax
Type Syntax Response Example
Set AT+UDCONF=3,<socket_id>,
<sending_timer_timeout>
OK AT+UDCONF=3,1,1000
OK
Read AT+UDCONF=3,<socket_id> +UDCONF: 3,<socket_id>,<sending_
timer_timeout>
OK
AT+UDCONF=3,1
+UDCONF: 3,1,1000
OK
18.18.3Defined values
Parameter Type Description
<socket_id> Number Socket identifier; used when changing the UDP Direct Link settings.
Allowed range is 0-6
<sending_timer_
timeout>
Number Sending timer (in milliseconds) for UDP direct link; valid range is 100-120000; the
default value is 1000 ms
18.19Timer Trigger configuration for Direct Link +UDCONF=5
+UDCONF=5
SARA-R404M SARA-R410M-01B SARA-R410M-02B SARA-R410M-52B SARA-R412MModules
SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error referenceAttributes
full No No No - +CME Error
18.19.1Description
Sets the timer trigger of the interested socket identifier for the data transmission enhanced Direct Link.
18.19.2Syntax
Type Syntax Response Example
Set AT+UDCONF=5,<socket_id>,
<timer_trigger>
OK AT+UDCONF=5,0,500
OK
Read AT+UDCONF=5,<socket_id> +UDCONF: 5,<socket_id>,<timer_
trigger>
OK
AT+UDCONF=5,0
+UDCONF: 5,0,500
OK
18.19.3Defined values
Parameter Type Description
<socket_id> Number Socket identifier; used when changing the UDP Direct Link settings.
Valid range is 0-6
<timer_trigger> Number Enhanced Direct Link sending timer trigger (in milliseconds); valid range is 0, 100 120
000; the factory-programmed value is 500 ms for UDP, 0 for TCP, 0 means trigger
disabled