Ublox SARA-R4 Series

SARA-R4/N4 series-AT Commands Manual
UBX-17003787 - R09

10V24 control and V25ter
Page 108 of 307
10.21Result code suppression Q
Q
SARA-R404M SARA-R410M-01B SARA-R410M-02B SARA-R410M-52B SARA-R412MModules
SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error referenceAttributes
full No Profile No - +CME Error
10.21.1Description
Determines if DCE transmits result codes to the DTE or not. When result codes are being suppressed,
no portion of any intermediate, final or URC is transmitted. Information text transmitted in response to
commands is not affected by this setting.
10.21.2Syntax
Type Syntax Response Example
Set ATQ[<value>] OK ATQ1
OK
10.21.3Defined values
Parameter Type Description
<value> Number
• 0 (default and the factory-programmed value): DCE transmits result codes
• 1: Result codes are suppressed and not transmitted
10.22DCE response format V
V
SARA-R404M SARA-R410M-01B SARA-R410M-02B SARA-R410M-52B SARA-R412MModules
SARA-N4
Syntax PIN required Settings saved Can be aborted Response time Error referenceAttributes
full No Profile No - +CME Error
10.22.1Description
Control the contents of the header and trailer transmitted with result codes and information text responses.
It also determines whether the result code is transmitted in a numeric form or an alphabetic (or verbose) form.
The information text response is not affected by this setting. See Information text responses and result codes
for description of the result code formats.
10.22.2Syntax
Type Syntax Response Example
Set ATV[<value>] OK ATV1
OK
10.22.3Defined values
Parameter Type Description
<value> Number
• 0: DCE transmits limited headers, trailers and numeric text
• 1 (default and the factory-programmed value): DCE transmits full headers, trailers
and verbose response text