SARA-R4/N4 series-AT Commands Manual
UBX-17003787 - R09

7Network service
Page 54 of 307
Parameter Type Description
• 1: IDLE
• 2: ATTEMPT TO CONNECT
• 3: CONNECTED
• 4: LEAVING CONNECTED STATE
• 5: ATTEMPT LEAVING E-UTRA
• 6: ATTEMPT ENTERING E-UTRA
• 255: not known or not detectable
<RI> Number Rank Indicator value; 255 if not known or not detectable. It is updated every 480 ms
with the value which has been most often reported to the network in the previous 480
ms period. See 3GPP TS 36.213 [130] section 7.2 and 3GPP TS 36.212 [131] section
5.2.2.6 for more details.
<CQI> Number Channel Quality Indicator value; 255 if not known or not detectable. It is updated
every 480 ms with the value which has been most often reported to the network in
the previous 480 ms period. See 3GPP TS 36.213 [130] section 7.2 for more details.
<avg_rsrp> Number Average value of last 10th Reference Signal Received Power (RSRP).
<totalPuschPwr> Number Mobile output power for PUSCH transmission averaged over 480 ms in dBm; 255 if
not known or not detectable.
<avgPucchPwr> Number Mobile output power for PUCCH transmission averaged over 480 ms in dBm; 255 if
not known or not detectable.
<drx> Number Discontinuous Reception "drx-Inactivity-Timer" value in ms; 0 if not known or not
detectable.
<l2w> Number SIB3 LTE to WCDMA reselection criteria: (threshServingLow)x2 +(q-RxLevMin)x2;
255 if not known or not detectable.
<volte_mode> Number Reserved for future use.
<meas_gap> Number Measurement gap configuration:
• 0: disabled
• 40: 40 ms measurement gap repetition period corresponding to the measurement
gap pattern ID 0 (see Table 8.1.2.1-1 of 3GPP TS 36.133 [105])
• 80: 80 ms measurement gap repetition period corresponding to the measurement
gap pattern ID 1 (see Table 8.1.2.1-1 of 3GPP TS 36.133 [105])
<tti_bundling> Number TTi (Transmission Time interval) bundling status:
• 0: off
• 1: on
<RSRP> String Reference Signal Received Power (RSRP) as defined in 3GPP TS 36.133 [105]
expressed in dBm
<RSRQ> String Reference Signal Received Quality (RSRQ) as defined in 3GPP TS 36.133 [105]
expressed in dB
7.9î™–î™–î™–î™–Edit Verizon wireless APN table +VZWAPNE
+VZWAPNE
Modules SARA-R404M
Syntax PIN required Settings saved Can be aborted Response time Error referenceAttributes
partial No NVM No - +CME Error
7.9.1î™–î™–î™–î™–Description
Reads and writes the APN table stored in the NVM:
• The set command causes the APN table on the DUT to be overwritten. A set command must be issued for
each APN edit.
• The read command queries the APN table that is currently on the DUT, starting from the first entry to the
last; it returns each APN entry in a new line.
If the command fails, an error result code is returned. See the 3GPP TS 27.007 [2] subclause 9.2 for <err> values.
To Next Page
Loading...
Need help?
General
