Ublox SARA-R4 Series - Page 15

SARA-R4/N4 series-AT Commands Manual
UBX-17003787 - R09

1AT command settings
Page 15 of 307
AT command S Number Description
S0 0 Automatic answer setting
S2 2 Escape character setting
S3 3 Command line termination character setting
S4 4 Response formatting character setting
S5 5 Command line editing character setting
S6 6 Pause before blind dialling setting
S7 7 Connection completion timeout setting
S8 8 Command dial modifier time setting
S10 10 Automatic disconnect delay setting
S12 12 Escape prompt delay setting
If a <parameter_number> other than those listed above is introduced, the S command returns an error
result code (+CME ERROR: operation not supported).