Ublox SARA-R4 Series - Page 170

SARA-R4/N4 series-AT Commands Manual
UBX-17003787 - R09

15GPIO
Page 170 of 307
15.4.3Defined values
Parameter Type Description
<gpio_id> Number GPIO pin identifier: pin number
See the GPIO mapping for the available GPIO pins, their mapping and factory-
programmed values on different u-blox cellular modules series and version.
<gpio_out_val> Number GPIO value. Allowed values are 0 and 1.
15.4.4Notes
• The command works only if the parameter <gpio_mode> of the +UGPIOC AT command is set to 0.