Ublox SARA-R4 Series - Page 212

SARA-R4/N4 series-AT Commands Manual
UBX-17003787 - R09

20FTP
Page 212 of 307
Type Syntax Response Example
Set AT+UFTP=5[,<timeout>] OK AT+UFTP=5,21
OK
FTP mode
Set AT+UFTP=6[,<FTP_mode>] OK AT+UFTP=6,1
OK
FTP server port
Set AT+UFTP=7[,<FTP_server_port>] OK AT+UFTP=7,30
OK
FTP Secure option in explicit mode
Set AT+UFTP=8[,<FTP_secure>[,
<USECMNG_profile>]]
OK AT+UFTP=8,1,2
OK
Read AT+UFTP? +UFTP: 0,<IP_address>
+UFTP: 1,<server_name>
+UFTP: 2,<username>
+UFTP: 4,<account>
+UFTP: 5,<timeout>
+UFTP: 6,<FTP_mode>
+UFTP: 7,<FTP_server_port>
[+UFTP: 8,<FTP_secure>[,
<USECMNG_profile>]]
OK
+UFTP: 0,"216.239.59.147"
+UFTP: 1,""
+UFTP: 2,"username"
+UFTP: 4,"account"
+UFTP: 5,0
+UFTP: 6,0
+UFTP: 7,21
+UFTP: 8,0
OK
Test AT+UFTP=? +UFTP: (list of supported <param_
tag>s)
OK
+UFTP: (0-8)
OK
20.1.3Defined values
Parameter Type Description
<op_code> String FTP parameter:
• 0: FTP server IP address
• 1: FTP server name
• 2: FTP username
• 3: FTP password
• 4: FTP additional user account
• 5: FTP inactivity timeout period
• 6: FTP mode
• 7: Remote FTP server listening port
• 8: FTP secure
<IP_address> String FTP server IP address. The default value is an empty string. For IP address format
reference see the IP addressing.
<server_name> String FTP server name (e.g. "ftp.server.com"). The maximum length is 128 characters. The
default value is an empty string.
<username> String User name (the maximum length is 30 characters) for the FTP login procedure. The
default value is an empty string.
<password> String Password (the maximum length is 30 characters) for the FTP login procedure. The
default value is an empty string.
<account> String Additional user account (if required) for the FTP login procedure. The maximum
length is 30 characters. The default value is an empty string.
<timeout> Number Inactivity timeout period in seconds. The range goes from 0 to 86400 s; 0 means no
timeout (the FTP session will not be terminated in the absence of incoming traffic).
The default value is 30 s.
<FTP_mode> Number FTP mode:
• 0 (default value): active
• 1: passive