SARA-R4/N4 series-AT Commands Manual
UBX-17003787 - R09

AAppendix: Error result codes
Page 258 of 307
Numeric error code Description
1018 No user responding
1019 User alerting, no answer
1021 Call rejected
1022 Number changed
1026 Non selected user clearing
1027 Destination out of order
1028 Invalid number format (incomplete number)
1029 Facility rejected
1030 Response to STATUS ENQUIRY
1031 Normal, unspecified
1034 No circuit/channel available
1038 Network out of order
1041 Temporary failure
1042 Switching equipment congestion
1043 Access information discarded
1044 requested circuit/channel not available
1047 Resources unavailable, unspecified
1049 Quality of service unavailable
1050 Requested facility not subscribed
1055 Incoming calls barred within the CUG
1057 Bearer capability not authorized
1058 Bearer capability not presently available
1063 Service or option not available, unspecified
1065 Bearer service not implemented
1068 ACM equal to or greater than ACMmax
1069 Requested facility not implemented
1070 Only restricted digital information bearer capability is available
1079 Service or option not implemented, unspecified
1081 Invalid transaction identifier value
1087 User not member of CUG
1088 Incompatible destination
1091 Invalid transit network selection
1095 Semantically incorrect message
1096 Invalid mandatory information
1097 Message type non-existent or not implemented
1098 Message type not compatible with protocol state
1099 Information element non-existent or not implemented
1100 Conditional IE error
1101 Message not compatible with protocol state
1102 Recovery on timer expiry
1111 Protocol error, unspecified
1127 Interworking, unspecified
1279 Number not allowed
1283 CCBS possible
1500 Wrong GPIO identifier
1501 Set GPIO default error
1502 Select GPIO mode error
1503 Read GPIO error
1504 Write GPIO error
1505 GPIO busy
1520 Wrong ADC identifier
1521 Read ADC error
1530 IPv4 only allowed
1531 IPv6 only allowed
1540 Wrong ringer identifier
To Next Page
Loading...
Need help?
General
