Ublox SARA-R4 Series - Page 33

SARA-R4/N4 series-AT Commands Manual
UBX-17003787 - R09

5Mobile equipment control and status
Page 33 of 307
Parameter Type Description
<bfr> Number
• 0: MT buffer of URCs defined within this command is cleared when <mode> 1...3 is
entered
• 1: MT buffer of URCs defined within this command is flushed to the DTE when
<mode> 1...3 is entered (the OK final result code shall be given before flushing the
codes).
<descr> Number Indicates the indicator order number. The name in the brackets indicates the
corresponding <descr> parameter of +CIND; <value> is the new value of indicator:
• 1 ("battchg"): <value> provides the battery charge level (0-5)
• 2 ("signal"): <value> provides the signal quality
o 0: < -105 dBm
o 1: < -93 dBm
o 2: < -81 dBm
o 3: < -69 dBm
o 4: < - 57 dBm
o 5: >= -57 dBm
• 3 ("service"): <value> provides the network service availability:
o 0: not registered to the network
o 1: registered to the network
• 4 ("sounder"): <value> provides the sounder activity:
o 0: no sound
o 1: sound is generated
• 5 ("message"): <value> provides the unread message available in <mem1> storage:
o 0: no messages
o 1: unread message available
• 6 ("call"): <value> provides the call in progress:
o 0: no call in progress
o 1: call in progress
• 7 ("roam"): <value> provides the registration on a roaming network:
o 0: not in roaming
o 1: roaming
• 8 ("smsfull"): <value> provides the SMS storage status:
o 0: SMS storage not full
o 1: SMS Storage full (an SMS has been rejected with the cause of SMS storage
full)
• 9 ("gprs"): <value> provides the GPRS indication status:
o 0: no GPRS available in the network
o 1: GPRS available in the network but not registered
o 2: registered to GPRS
o 65535: PS service indication is not available
• 10 ("callsetup"): <value> provides the call set-up:
o 0: no call set-up
o 1: incoming call not accepted or rejected
o 2: outgoing call in dialing state
o 3: outgoing call in remote party alerting state
• 11 ("callheld"): <value> provides the call on hold:
o 0: no calls on hold
o 1: at least one call on hold
• 12 ("simind"): <value> provides the SIM detection:
o 0: no SIM detected
o 1: SIM detected
o 2: not available