EasyManua.ls Logo

Ublox SARA-R4 Series - Page 52

Ublox SARA-R4 Series
307 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SARA-R4/N4 series-AT Commands Manual
UBX-17003787 - R09
7Network service
Page 52 of 307
Parameter Type Description
<Grac> Number One byte routing area of the GERAN cell in hexadecimal format; FF if not known or not
detectable.
<rxlev> Number GERAN cell Received Signal Strength Indicator (RSSI) index as defined in 3GPP TS
45.008 [28]:
0: less than -110 dBm
1..62: from -110 to -48 dBm with 1 dBm steps
63: -48 dBm or greater
255: not known or not detectable
<grr> Number Reserved for future use.
<t_adv> Number Reserved for future use.
<Gspeech_mode> Number Reports the latest obtained value of the GSM speech code. Allowed values:
0: GSM Enhanced Full Rate (12.2 kb/s)
1: GSM Full Rate (13.0 kb/s)
2: GSM Half Rate (5.6 kb/s)
3..10: AMR NB FR (from 4.75 kb/s to 12.2 kb/s) the value indicates the first codec
type chosen from the DUT; see the corresponding value of <Wspeech_mode>
parameter for the baud rate mapping
3..8: AMR NB HR (from 4.75 kb/s to 7.95 kb/s) the value indicates the first codec type
chosen from the DUT; see the corresponding value of <Wspeech_mode> parameter
for the baud rate mapping
11..13: AMR WB FR (from 6.60 kb/s to 12.65 kb/s) the value indicates the first
codec type chosen from the DUT; see the corresponding value of <Wspeech_mode>
parameter for the baud rate mapping
255: not known or not detectable
See 3GPP TS 26.201 [113] for more details on GSM codecs used during a voice call
In case a set of speech codecs is assigned by the network, then the parameter
reports the lowest one and this one is not necessary the one used.
<uarfcn> Number UTRAN Absolute Radio Frequency Channel Number (UARFCN); the range is 1537-10
838, 65535 if not known or not detectable.
<Wband> Number UTRAN band:
1: band 1 (2 GHz)
2: band 2 (1900 MHz)
4: band 4 (2100 MHz)
5: band 5 (800 MHz)
8: band 8 (900 MHz)
255: not known or not detectable
<WcellId> Number UTRAN CI (cell identifier) in hexadecimal format; the range is 0h-FFFFFFFh (28 bits),
0000000 if not known or not detectable.
<Wlac> Number Two bytes location area of the UTRAN cell in hexadecimal format; FFFF if not known
or not detectable.
<Wrac> Number One byte routing area of the GERAN cell in hexadecimal format; FF if not known or not
detectable.
<scrambling_code> Number Primary Scrambling Code; range 0-512, 0 if not known or not detectable.
<Wrrc> Number 3G RRC state:
0: idle
1: URA_PCH
2: CELL_PCH
3: CELL_FACH
4: CELL_DCH
255: not known or not detectable
<rssi> Number UTRAN cell Received Signal Strength Indicator as defined in 3GPP TS 25.133 [106]:
0: less than -100 dBm
1..75: from -100 to -25 dBm with 1 dBm steps
76: -25 dBm or greater
255: not known or not detectable
<ecn0_lev> Number UTRAN cell Ratio of received energy per PN chip to the total received power spectral
density as defined in 3GPP TS 25.133 [106]:
0: less than -24 dB

Table of Contents

Other manuals for Ublox SARA-R4 Series

Related product manuals