Enhanced phone functions 59
Two-way intercom to a variable destination
When using the two-way intercom in a group, the loudspeaker and microphone
of the destination phone are automatically switched on.
^ Lift the handset.
or
Speaker Press the key shown for speakerphone mode.
j Enter the system code for "Speaker call-two-way" (consult your administrator if
necessary).
or
S Press the programmed "COM Spk 2way" key.
j Enter the speed-dial number for the corresponding group member.
The loudspeaker and microphone of the destination phone are switched on
automatically.
Two-way intercom to a fixed destination
The system code for "Speaker call-two-way" and the speed-dial number for the
corresponding group member are programmed on the repdial key
Page 68.
S Press the programmed key.
The loudspeaker and microphone of the destination phone are switched on
automatically.
Announcement (broadcast) to all members of a line
trunk group
You can use this function to send an announcement to all members (10 to 40) of
a line trunk group.
Z Once you have activated the group call, you will hear a confirmation tone. You
can then begin the announcement.
^ Lift the handset.
or
Speaker Press the key shown for speakerphone mode.
j Enter the system code for "Speaker call-1-way bcst" (consult your administrator
if necessary).
or
S Press the programmed "Broadcst Spk" key.
j Enter the internal phone number of a group member.
Z The loudspeakers on all group phones are automatically switched on and you
will hear a confirmation tone. You can begin the announcement.
\ You end the announcement by replacing the handset.
^ If a group member lifts their handset, they are connected to you and the
announcement is ended.
Speaker
or S If a group member presses the speaker key or the relevant line key for the
announcement, they are disconnected from the announcement. If the last
remaining member of the group presses the speaker key or line key, the
announcement ends.
To Next Page
Loading...
