UniPOS FS5200E - Page 41

UniPOS Fire Extinguishing Control Panel FS5200Е
Instruction Manual Page 41
Revision 7/06.12 of 63
Screen Number of Checks
In order the number of the false
activations to be reduced, the fire
extinguishing control panel provides the
option to setup a parameter indicating the
number of the activations of an automatic fire
detector within 60 seconds that would trigger
the fire extinguishing control panel for fire
condition. This screen provides information
about the parameter value.
1 2 3
Screen Check removed FD
The fire extinguishing control panel
recognizes the fault condition Removed Fire
Detector if the bases that are used are
diodes. Otherwise the function Removed Fire
Detector should be switched off.
1 2 3
Screen Input Hold
The screen provides information
about if the input ‘Hold’ is active or not and
the status of the contacts.
1 2 3
Screen Input LowPress
The screen provides information about
if the input ‘LowPress’ is active or not and
the status of the contacts.
1 2 3