Unipulse F381A - Page 155

146
9 SUPPLEMENTS
146
SUPPLEMENTS
Chapter
9
*2: [NOV RAM : N] [SRAM : S]
Item Set value Input range (display range)
Initial
value
Memory
＊2
Remarks
Section 1 to 5 Load HI/LO Limit
(HI limit, LO limit)
-9999 to +9999 -99.99
to 99.99kN
S
DPM HI/LO Limit
(HI limit, LO limit)
Waveform Reference; Front
0 to 2047 × Measurement Length/2000
Waveform Reference; Back
-2047 to 0 × Measurement Length/2000
* When End Displacement in Use Hold
is selected; -9999 to 32000
0 to
61.41mm
S
Start Load -9999 to 9999 1.00kN S
Load Difference 1 to 19998 1.00kN S
Rate 0 : 1/4 1 : 1/2
2 : 3/4 3 : 1
4 : 1.25 5 : 1.5
6 : 1.75 7 : 2
8 : 3 9 : 4 [Times]
3/4 Times
S
Ordinal 1 to 15 [Times] 1 Times S
Interval AB
(Inflection PointA,
Inflection PointB)
1 to 999 × Measurement Length/2000
100ms,
100ms S
Waveform
Comparison
Setting
Reference Wave
Compare Area
(start point,end point)
Time or displacement (Front)
0 to 2047 × Measurement Length/2000
Displacement (Back)
-2047 to 0 × Measurement Length/2000
0 to
2047ms
S
Shift
Range;
Time or displacement (Front)
0 to 2047 × Measurement Length/2000
Displacement (Back)
-2047 to 0 × Measurement Length/2000
Amount of movement : -19998 to +19998
0 to
2047ms
0.00kN
Tie Drawing
Compare Margin 0 to 9999 0kN S
Relative
(common to all work)
0 : Off 1 : On Off
S
Relative Point X-axis :
Time or displacement (Front)
0 to 2047 × Measurement Length/2000
Displacement (Back)
-2047 to 0 × Measurement Length/2000
Y-axis : -9999 to 9999
X-axis
: 0ms
Y- ax is
: 0.00kN
S
Wave Save