145
9 SUPPLEMENTS
145
SUPPLEMENTS
Chapter
9
*2: [NOV RAM : N] [SRAM : S]
Item Set value Input range (display range)
Initial
value
Memory
＊2
Remarks
Display
Range
Setting
Y Start Point -10000 to 10000 0.00kN S
Y End Point Y-axis Start Point +
0 : 25 1 : 50
2 : 100 3 : 200
4 : 300 5 : 400
6 : 500 7 : 1000
8 : 2000 9 : 3000
10 : 4000 11 : 5000
12 : 10000 13 : 20000
20.00kN
S
X Start Point Time or displacement (Front)
0 to 2000
×
Measurement Length/2000
Displacement (Back)
-2000 to 0
×
Measurement Length/2000
0ms
S
X End Point Time or displacement (Front)
X-axis Start Point +
0 : 25 1 : 50
2 : 100 3 : 200
4 : 400 5 : 600
6 : 800 7 : 1000
8 : 1200 9 : 1400
10 : 1600 11 : 1800
12 : 2000 13 : 2200
× Measurement Length/2000
Displacement (Back)
X-axis Start Point +
0 : -25 1 : -50
2 : -100 3 : -200
4 : -400 5 : -600
6 : -800 7 : -1000
8 : -1200 9 : -1400
10 : -1600 11 : -1800
12 : -2000 13 : -2200
× Measurement Length/2000
2000ms
S
Hold Setting Change of Sct.
(common to all work)
0 : External Input 1 : Setting
（0 can be set only when the
time or displacement (Front))
Setting
S
Use Sct. 1 to 5 1 S
Sct. No.
(for RS-232C
communications)
0 : Sct1 1 : Sct2
2 : Sct3 3 : Sct4
4 : Sct5
S
Section 1 to 5 Use Hold 0 : Always 1 : Sample
2 : Peak 3 : Bottom
4 : Peak to Peak
5 : Relative Maximum
6 : Relative Minimum
7 : Inflection Point
8 : Average
9 : End Displacement
Always
S
Sct. Start-End
(start point,end point)
Time or displacement (Front)
0 to 2047
×
Measurement Length/2000
Displacement (Back)
-2047 to 0
×
Measurement Length/2000
0 to
2047ms
S
To Next Page
Loading...
