Unipulse F381A - Page 153

144
9 SUPPLEMENTS
144
SUPPLEMENTS
Chapter
9
*1: Function-specific set values (calibration values, etc.); currently set values remain even if initialization is
executed.
*2: [NOV RAM : N] [SRAM : S]
■Settings by work [Work 0 to 15, All]
*2: [NOV RAM : N] [SRAM : S]
Item Set value Input range (display range) Initial value
Memory
＊2
Remarks
System
Setting
Backlight
(ON Time)
(bright→dark）
0 to 9999 10 minutes
(ON Time)
0 minutes
(bright→dark）
N
Language
＊1
0 : Japanese
1 : English
Japanese
N
Work Protect 0 : Not Protect 1 : Protect Not Protect N
First Protect 0 : Not Protect 1 : Protect Not Protect N
Initialization 0 : First Setting Parameter
1 : Work Setting Parameter
2 : All Parameter
Self-Check
Analog output filter 0 : OFF 1 : ON ON N
Password 0 to 9999 0
Time Adjust
＊1
2001/01/01 00:00:00
to 2079/12/31 23:59:59
2001/01/01
00:00:00
S
Item Set value Input range (display range)
Initial
value
Memory
＊2
Remarks
Settings by
work
Work No. 0 to 15 0
Copy No. 0 to 15 0
Measurement
Start
Condition
Setting
Start Condition 0 : Only External Input
1 : External Input + Load
2 : External Input + Displacement
(2 can be set only when the X-axis
of the waveform represents
displacement.)
External
Input + Load
S
Start Level External Input + Load
: -9999 to +9999
External Input + Displacement
: -9999 to +32000
1.00kN
S
Stop Condition 0 : Only Forced-Stop
1 : Load
2 : Time
3 : Displacement
4 : Displacement Stop
(3 and 4 can be set only when the
X-axis of the waveform represents
displacement.)
Only
Forced-
Stop
S
Stop Level Load: -9999 to +9999
Time: 0.1 to 10.0 [second]
Displacement: -9999 to +32000
Displacement Stop: 0.1 to 10.0
[second]
1.00mm
S