W A S H S E L E C T I I
Document Number: WS21002 109
Document Title: WSII Operations Manual
3 . 3 . 1 . 6 C l e a n i n g a n d G e n e r a l M a i n t e n a n c e
The AE2600 series will not need cleaning as often as magnetic sensing bill validators. If
cleaning is required, use a soft cloth moistened with mild, non-abrasive detergent.
3 . 3 . 1 . 7 P r o g r a m m i n g t h e M a r s B i l l V a l i d a t o r
The Mars Bill Validator allows programming for a maximum-security setting, as well as a
setting for a specified direction that a bill can be inserted. These options are set by a DIP
switch package located on one side of the validator.
To change any of the options, perform the following steps.
20. Remove the Mars Bill Validator from the unit.
21. Referring to Error! Reference source not found., use a small flat-head
screwdriver to set the DIP switches for the options you prefer. (See Error!
Reference source not found. for DIP switch location.)
Figure 16. Mars DIP Switches
To Next Page
Loading...
Need help?
General