W A S H S E L E C T I I
Document Number: WS21002 84
Document Title: WSII Operations Manual
79. Click the Next button.
80. Select the “Do not run the hardware installation wizard” box if not checked.
81. Click the Next button.
82. Select the “Do not detect my modem, I will select it from a list.” Box if it is not
checked.
83. From the window, select Standard modem types for the manufacturer.
84. Select the baud rate of your modem. If your modem exceeds 28800, select
28800.
85. Click the Next Button. You may be prompted to insert your Windows 95/98 disk.
86. After the new modem is installed, go into the HyperTerminal connection that you
created for your site earlier.
87. Click File Properties from HyperTerminal.
88. Select the new modem you installed.
2.13.11 Disabling Error Control
Disabling error control may be required for some modems when accessing a Wash Select II
with the DataTran modem (installed when the Credit Option is purchased). If you cannot
install a standard modem, you may alternatively modify the currently installed modem. We do
not recommend this unless you are only using your modem to connect to the Wash Select II
system. This may alter your performance with Internet services. We would then recommend
that you purchase another modem for your computer. We recommend US Robotics Sportster
(not Win modem) modems. A 28.8 US Robotics modem is more than sufficient for connecting
to a Wash Select II.
Disabling Hardware Error Control:
89. From windows click Start-> Settings -> Control Panel.
90. Select the Modem icon.
91. Select your modem from the list.
92. Click the Properties button.
93. Select the Connection Tab.
94. Click the Advanced Button.
95. Make sure the “Use Error Control” box is NOT checked.
96. Select OK in the “Advanced Connection settings” menu.
97. Select OK in the XXXXXX Modem properties window. (XXXXXX represents the
name of your modem).
98. Select Close in the Modem properties window.
To Next Page
Loading...
Need help?
General