W A S H S E L E C T I I
Document Number: WS21002 79
Document Title: WSII Operations Manual
Figure 6. HyperTerminal New Connection Window
24. Add the name of your site in the Name: field, and select an Icon if you wish.
When you do, the “Connect To” screen will be displayed.
25. In the “Connect To” window, add the phone number. (Note: if your phone area
requires you to enter a 10-digit number, enter the area code and phone number.
26. Select the modem you have installed under the “connect using” drop down box.
27. Click OK on the “Connect To” box.
28. On the “Connect” window, verify the “Phone number”. This is the number that will
be dialed. If it is not correct or the number doubles up on the area code, click the
“Dialing Properties” button.
29. You may have to change some of the settings including the “Dial as a long
distance call” check box.
30. If you had to change the properties, click OK.
31. From the Connect window click “Cancel, do not Dial” for now.
32. From the File menu, click Save to save this connection.
33. For further information about HyperTerminal, select Help topics in the Help menu.
34. Exit HyperTerminal.
2.13.5 Dialing and Connecting to a Site
35. Enter your new connection by selecting the Icon in the HyperTerminal folder for
the connection that you just added.
36. Select Dial to connect.
37. After connecting, you will be prompted to enter your password.
38. Depending on the program’s settings, you may not see the characters that you
are typing.
To Next Page
Loading...
Need help?
General