Utax 2550ci

Troubleshooting
12-4
Images are skewed.
Are the originals placed
correctly?
When placing originals on the
platen, align them with the original
size indicator plates.
2-42
When placing originals in the
optional document processor, align
the original width guides securely
before placing the originals.
2-42
Is the paper loaded
correctly?
Check the position of the paper
width guides.
2-29
— Perform center line adjustment.
For more information about how to
do so, contact your service
representative.
—
Paper often jams. Is the paper loaded
correctly?
Load the paper correctly. 2-29
2-32
— Turn the orientation 180 degrees
around in which the paper is
positioned.
xxxviii
2-29
2-32
Is the paper of the supported
type? Is it in good condition?
Remove the paper, turn it over, and
reload it.
2-29
Is the paper curled, folded or
wrinkled?
Replace the paper with new paper. 2-29
Are there any loose scraps or
jammed paper in the
machine?
Remove any jammed paper. 12-18
Printouts have black
lines.
Is the slit glass dirty? Clean the slit glass. 11-11
— Run [Laser Scanner Cleaning]. 9-74
2 or more sheets are
overlaps when
ejected. (multi feed)
— Load the paper correctly. 2-28
Symptom Checkpoints Corrective Actions
Reference
Page