Troubleshooting
12-5
12
Printouts are
wrinkled.
— Turn the orientation 180 degrees
around in which the paper is
positioned.
xxxviii
2-29
2-32
Is the paper damp? Replace the paper with new paper. 2-29
Printouts are curled. — Turn the orientation 180 degrees
around in which the paper is
positioned.
xxxviii
2-29
2-32
Is the paper damp? Replace the paper with new paper. 2-29
Cannot print. Is the machine plugged in? Plug the power cord into an AC
outlet.
2-6
Is the machine powered on? Turn on the main power switch. 2-7
Are the printer cable and
network cable connected?
Connect the correct printer cable
and network cable securely.
2-3
Was the machine powered
on before the printer cable
was connected?
Power on the machine after
connecting the printer cable.
2-3
Is the print job paused? Resume printing. 8-3
Cannot print with USB
memory.
USB memory not
recognized.
Is the USB host blocked? Select [Unblock] in the USB host
settings.
9-107
— Check that the USB memory is
securely plugged into the machine.
—
Dirt on the top edge
or back of the paper.
Check the paper chute and
the ramp.
Open the right cover and check for
toner on the paper ramp inside the
paper transfer unit. Clean the
paper ramp using a soft, dry, lint-
free cloth.
—
Part of the image is
periodically faint or
shows white lines.
— Open and then close the right
cover.
—
— Run [Drum Refresh]. 9-68
— Run [Developer Refresh]. 9-74
— Contact your service
representative.
—
Symptom Checkpoints Corrective Actions
Reference
Page
To Next Page
Loading...
