Utax 2550ci

Troubleshooting
12-13
12
* When Auto Error Clear is set to [On], processing resumes automatically after a set amount of time elapses.
Message Checkpoints Corrective Actions
Reference
Page
Removable memory
is full.*
— This job is canceled. Press [End].
Insufficient free space in the
removable memory. Delete unneeded
files.
—
Replace all originals
and press [Continue].
— Remove originals from the document
processor, put them back in their
original order, and place them again.
Press [Continue] to resume printing.
Press [Cancel] to cancel the job.
2-42
Remove originals in
the document
processor.
Are there any originals left in
the document processor?
Remove originals from the document
processor.
—
Scanner memory is
full.*
—
Scanning cannot be performed due to
insufficient memory of the scanner. Follow
the instructions on the touch panel.
—
Send error.* — An error has occurred during
transmission. The job is canceled.
Press [End]. Refer to Responding to
Send Error for the error code and
corrective actions.
12-15
Staple is empty.* Has the document finisher
run out of staples?
If the staples are depleted, the
machine will stop and the location of
staple depletion will be indicated on
the touch panel.
Leave the machine on and follow the
instructions to replace the staple case.
Press [Continue] to print without stapling.
Press [Cancel] to cancel the job.
—
Staple jam. — If a staple jam occurs, the machine
will stop and the location of the jam
will be indicated on the touch panel.
Leave the machine on and follow the
instructions to remove the jammed staple.
—
System error. — System error has occurred. Follow
the instructions on the touch panel.
When turning off the main power
switch, do not turn on the main power
switch again immediately. Wait more
than 5 seconds, and then turn on the
main power switch.
2-7
The cover is open. Is there any cover which is
open?
Close the cover indicated on the
touch panel.
—