1-3-1
2DA/2DB
1-3-1 Unpacking and installation
(1) Installation procedure
Unpack.
Install the optional paper feeder.
Remove the tapes and pins.
Install the original cover or the optional DP.
Connect the power cord.
Load paper.
Make test copies.
Output an own-status report
(maintenance item U000).
Exit maintenance mode.
Start
Install the toner container.
Installing the toner
(maintenance item U130).
Install the optional duplex unit.
Install the optional finisher or job separator.
End of installation.
To Next Page
Loading...
Need help?
General
