To Next Page

To Previous Page

P/N 06-237041-001 i February 2011

FOREWORD

Note: This Manual, P/N 06-237041-001, is to be used by qualified and factory-trained personnel, knowledgeable

of NFPA standards and any other applicable standards in effect.

This Manual is intended to provide guidance to qualified technical professionals for the installation, operation and

maintenance of the FenwalNET 8000-ML

Intelligent Fire Alarm-Suppression Control Unit.

Only qualified persons experienced and trained in the installation of this type of equipment should install and

configure the FenwalNET 8000-ML. They must be familiar and experienced with the wiring diagrams and

components, electrical installation, and familiar not only with NEC, relevant NFPA and local codes but also trained

and qualified by Kidde-Fenwal, Inc. Kidde-Fenwal, Inc. is a manufacturer of the components that make up the

FenwalNET 8000-ML system, and may not have the opportunity to visit the sites where the product is installed

or intended to be installed. It is the responsibility of the professional installer (described above) to properly install

and configure the systems. Under no circumstances will Kidde-Fenwal, Inc. be liable for improper installation or

configuration of the systems.

The technical data contained herein is provided for informational purposes only, and should not be used as a

substitute for professional judgment. Although, Kidde-Fenwal, Inc. believes this information to be true and correct,

it is published and presented without any guarantee or warranty whatsoever. Kidde-Fenwal, Inc. disclaims any

liability for any use of the data other than as set out in this manual, foreword included.

Any questions concerning the information presented in this manual should be addressed to:

Kidde-Fenwal, Inc.

400 Main Street

Ashland, MA 01721, USA

Phone: (508) 881-2000

Toll Free: (800) 872-6527

Technical Support: (866) 287-2531

Fax: (508) 881-8920

UTC Fire and Security FenwalNET 8000-ML User Manual

Questions and Answers: