UVITEC – Cambridge
15/225
FIREREADER
FIREREADERFIREREADER
FIREREADER
SERIES
SERIESSERIES
SERIES
I
N S T A L L I N G T H E
F
I R E
R
E A D E R
Unpacking the system
Please, open the F
IRE
R
EADER
box carefully and verify the contents:
Darkroom / Camera and camera support 1
Power cable 1
Instruction manual 1
FireReader 1D software CD-Rom inside the instruction manual 1
USB cable for Auto version only (motorised zoom) 1
Remove carefully each component from the box.
Remove their protective plastic cover.
Place the darkroom at its permanent location, the door facing forward. The cabinet has to be placed
near the computer used for image acquisition.
It is recommended that the F
IRE
R
EADER
darkroom be carried by at least two people
– one on each side- holding the instrument from the bottom side. Be sure that the
door is properly closed when carrying the instrument.
Do not connect the power cable to a power source until all connections are made.
The power source has to be grounded and protected by a circuit breaker.
The FireReader system is designed to fit a specific voltage. Please, check the
voltage to ensure it corresponds to the FireReader specifications.
To Next Page
Loading...