FIREREADER
FIREREADER FIREREADER
FIREREADER SERIES
SERIESSERIES
SERIES
F
I R E
R
E A D E R
1 D
S O F T W A R E I N S T A L L A T I O N
Pre-requirement
Please read carefully the installation instruction before proceeding to the installation.
Please do not connect the FIREREADER USB camera to the computer before installing
the FireReader 1D software.
After the software is fully installed, connect the FireReader USB camera to the computer. At
that time, Windows 7, Vista or XP will look for the camera driver located in the CD-Rom.
The FireReader system should be switched off before any software installation.
Software installation – Preliminary steps
The CD disk provided with your FireReader system contains the Capt Advance software and
driver.
Capt Advance runs with Microsoft Windows
TM
XP (32-bit mode), Vista (32-bit or 64-bit mode)
and Windows 7 (32-bit or 64-bit mode).
Windows® is a registered trademark of Microsoft.
You must have Windows
TM
administrator permission to install the Capt Advance software
Note: During the driver installation, the Windows installation CD-ROM might be required.
Please, check you have it before starting the Capt Advance software installation
To Next Page
Loading...