5. Make your changes by enabling the plot parameters you want to use and typing
relevant values in the Scale Limits column:
Wind Speed
Select to chart the wind speed in the graph.
Type a value to specify the maximum wind speed you want to plot.
Wind Direction
Select to chart the wind direction. You cannot edit the Scale Limits column for
this field.
Divergence
Select to chart the wind divergence. Type a value to specify the maximum
divergence you want to plot.
Vertical Velocity
Select to chart the vertical velocity. Type a value to specify the maximum vertical
velocity you want to plot.
Deformation
Select to chart the horizontal deformation. Type a value to specify the maximum
deformation you want to plot.
Axis of Dilation
Select to chart the axis of dilatation. You cannot edit the Scale Limits column for
this field.
Reflectivity
Select to chart the reflectivity. Type a value to specify the maximum reflectivity
you want to chart.
Max Height in km
Type the maximum height for the data to include in the plot.
Std Dev Thresh %
Enter the standard deviation threshold percent for the data to include in the plot.
This is used to threshold poor estimates. The scale goes from 0 (no thresholding)
to 100 (total thresholding). 80 is a typical value.
Alternatively, select Defaults to use a reasonable set of default values as a starting
point.
6. Select Apply.
Your changes are shown in the current VVP display as a graph.
7. Select Display Options > File > Save.
More information
‣
Producing VVP Product Output (page 99)
‣
VVP Output Options: Time-Height (page 251)
Chapter 6 – Quick Look Window
RESTRICTED 255
To Next Page
Loading...