See also
Quick Start ATP Configuration for EN50136 ATS below
Configuring Event Profiles on page319
Event Exception Definition on page320
Configuring Command Profiles on page322
FlexC Status on page192
Configuring an EN50136-1 ATS or Custom ATS on page307
17.11.2.1 Operation Mode
The system uses the store-and-forward method when communicating events.
The SPC Alarm System sends events to SPC Com XT and requires an acknowledgment from SPC Com
XT before the SPC Alarm System considers the event to have been successfully transmitted. SPC Com
XT only acknowledges the event after it has successfully written the event to the SQL database. SPC
Com XT then forwards the event to the SPC Com XT Client and Sur-Gard interfaces.
17.11.2.2 Quick Start ATP Configuration for EN50136 ATS
FlexC provides the following out of the box features that enable you to get FlexC up and running quickly:
l Quick start configuration page for an EN50136 Single Path ATS, Dual Path ATS and Dual Path
Dual Server ATS
l Default Event Profile
SPC4xxx/5xxx/6xxx – Installation & Configuration Manual Engineer programming via the browser
© Vanderbilt 2018 305 A6V10276959-d
11.2018
To Next Page
Loading...