Vacuum Packaging Machine VC999 K7
Operation
2008-11-26 Art.-No. 592.016 Page 37/121
Recommended settings
for product heights
to approx. 150 mm
no intermediate rods
(sealing height = 40 mm)
product heights
from approx. 150 mm
to approx. 250 mm
1x intermediate rod (40 mm)
(sealing height = 80 mm)
NOTICE
If the height of the sealed seam is moved, both sealing bars, i.e. the lower and upper sealing
bars have to be moved. The guide plate on the infeed conveyor then also needs to be adjusted
to the new height.
NOTICE
The two sealing sides (left and right) may be at different heights.
Moving the lower sealing bars
Procedure:
1. Switch off the machine.
2. Lift the sealing bar (1) off the bolts (2, 3). Use a screwdriver held at an angle to remove firmly
seated sealing bars.
Fig. 9/1
3. Remove the pre-perforation hold-down clamp (4) from the sealing bar (1) by unscrewing the two
screws (5).
4. Use the two screws (5) to attach the pre-perforation hold-down clamp (4) to the intermediate rod
(6).
To Next Page
Loading...
