Risk of Electric Shock
There is a risk of an electric shock which may lead to personnel injury or death. To prevent or avoid such a
situation, the following points must be taken into consideration:
• Disconnect the control box and remote power supplies prior to working on the product.
• Local codes, regulations, and protocols may vary from region to region. Therefore, adhere to all these local
protocols and rules prior to installing, operating, or servicing of the machine.
• Read all the instructions, ensure that all the parts and components are included, and check the nameplate
to ascertain that the voltage matches the available mains; Proceed with the installation, maintenance,
troubleshooting, and operating on the machine only after going through the preceding steps.
• Before connecting the input power (including the AC mains and battery), ensure that the grounding is
reliable. Remember that the leakage current to earth is greater than 3.5 mA and lower than 5% of the input
current.
• Finally, read all the labels on the unit and its components before operating on those components during
installation and maintenance. The warnings and cautionary measures mentioned in this manual are
supplementary and therefore, the measures listed on the labels of the components and the unit must be
considered strictly before any operation.
General Safety Instructions
• Use the tools with an insulation handle.
• Wear rubber gloves and safety shoes.
• Avoid placing tools and metal objects on the battery surface.
• Remove the watches, rings, or any metal objects.
• Only after all the power is disconnected, operate on the inner components of the product.
• Before operating on the inner components for any maintenance, ensure to switch o the mains breaker
and all UPS power.
To Next Page
Loading...
