Vertiv SmartCabinet - 2.2.3. Weight Bearing capacity; 2.3. Installation

Vertiv | SmartCabinet | User Manual 25
System Installation
2.2.3. Weight Bearing capacity
The SmartCabinet solution is on the heavier side; therefore, the weight bearing capacity of the oor of the
computer room must be taken into consideration.
Refer to Table 1-6 under the Specications section for the weights of the dierent models. However, during
installation, the weight bearing capacity of the oor should also be estimated based on the total weight of the
cabinet which also includes the installed equipment.
If the weight bearing capacity cannot be estimated, consult the nearest Vertiv oice or the customer service/
support center.
2.3. Installation
In this section, the installation will be explained in detail. Ensure that all the installation tools and ttings are
available prior to installation.
Following are some safety measures that must be observed prior to installation of the SmartCabinet system:
• Before installation, ensure that the installation site is plane. The site gradient level has to be conrmed
and should meet the requirements.
• Switch o the power during installation. Operation on any electried equipment is forbidden. The con-
necting cable must comply with related requirements.
• Pay attention to the installation requirements of the indoor and outdoor units while installing the Air
conditioning unit.
• Close all the doors while lifting the equipment using an electric forklift or a pallet.
• For the unit with an integrated condenser, ensure that there is suicient space for the air outlet and air
inlet of the cabinet.