VHF Z4 - Emergency opening of the multi-purpose drawer

Removing the back panel cover
You need to remove the back panel cover of the
machine for an emergency release of the multi-
purpose drawer.
You can remove the back panel cover as follows:
1.
Switch off the machine at the main power switch.
2.
Disconnect the machine from all lines.
3.
Grab the bottom edge of the back panel cover
and pull it towards you as indicated by the
arrows:
F
IG
. 61 – R
EMOVING THE BACK PANEL COVER
4.
To re-install the back panel cover, do the fol-
lowing:
a.
Align the top edge of the machine and the
cover so that the start button and main
power switch lie in the center of the respect-
ive openings.
b.
Push the cover against the machine hous-
ing.
The cover is held in place by magnets.
Emergency opening of the multi-
purpose drawer
In case of a longer power failure, you can manually
open the multi-purpose drawer as follows:
1.
Remove the back panel cover (
Ž
Removing the
back panel cover
– see above
).
2.
Insert a screwdriver with 5cm minimum length
into the depicted opening at the backside of the
machine.
F
IG
. 62 – E
MERGENCY RELEASE OF THE MULTI
-
PURPOSE DRAWER
3.
Push the screw driver in the upper right direction
until you encounter a resistance.
4.
Use the screwdriver to push the lever for the
emergency release to the left until the mech-
anism is unlocked.
5.
Install the back panel cover.
Original Operating Instructions:Z4
Version: 12/5/2018
Z4 – Operation: Executing jobs
EN 52