VHF Z4 - Transportation and storage

Transportation and storage
WARNING
Injuries caused by unsafe transportation
If you transport the machine unsafely, the machine
may slip and cause injuries.
Always transport
unpacked
machines indi-
vidually and do not stack them.
Ensure that only trained personnel transport the
machine to and from the installation site.
Ensure that the housing of the machine is com-
pletely closed.
Always transport the machine in an upright pos-
ition.
Transport and position the machine with
2people.
Before carrying an unpacked machine, install the
carrying aid that was provided with the machine
and ensure that all components are properly fixed.
Do not use a different carrying aid
.
Grab unpacked machines only at the
handles of the carrying aid.
Do not tilt
the machine when carrying it.
The supplement about the carrying aid and
transport lock is delivered with the machine.
It is also downloadable at
dentalportal.info/downloads
.
Ensure that the following conditions are met dur-
ing the whole transport and/ or storage period:
n
Ambient temperature (storage/ transport):
between -20°C and 60°C
n
Relative air moisture: max. 80, non-con-
densing
Preparing transportation or storage
Before transporting or storing your machine, the
following preparations are necessary:
1.
Remove all blanks from the working chamber.
2.
Remove the tool magazine from the working
chamber.
3.
Rinse the cooling liquid system.
4.
Drain and clean the cooling liquid tank.
5.
Clean the working chamber.
6.
Install the transport lock. For this, follow the cor-
responding steps on the supplement in reverse
order.
7.
Ensure that the housing of the machine is com-
pletely closed.
8.
Shut down the machine via the touchscreen.
9.
Switch off the machine at the main power switch.
10.
Disassemble the machine components by fol-
lowing the installation instructions in reverse
order.
11.
If you need to carry the machine, install the car-
rying aid. For this, follow the corresponding steps
on the supplement in reverse order.
12.
In case of overseas transport, take proper meas-
ures against corrosion.
Repackaging
To repack the machine after preparing its trans-
portation or storage, the following steps are neces-
sary:
1.
If possible, use the original packaging. If the ori-
ginal packaging is not available, use a packaging
of similar size and quality.
Original packaging is available from
customer service.
2.
Pack the machine and its accessories securely.
3.
Protect the packaging against slipping. If
machines are properly packed and protected
against slipping, they may be stacked.
Z4 – Operating regulations
EN 9
Original Operating Instructions:Z4
Version: 12/5/2018