VHF Z4 - Accessing the CAM computer

6.
If a local network is not available, connect the
CAD computer to the Ethernet port of the
machine with an Ethernet cable.
7.
Ensure that the internal CAM computer of the
machine has access to the Internet.
n
If required, configure your network firewall
accordingly.
n
If permanent Internet access cannot be guar-
anteed, ensure that the machine is con-
nected to the Internet at least once per
week.
The machine requires Internet access for
important updates.
8.
Switch on the machine at the main power switch.
Press the start button.
9.
Wait until the machine has referenced.
Accessing the CAM computer
NOTICE
Installing Microsoft
®
Office onto the
CAMcomputer violates the Windows
®
License Agreements
The CAM computer runs Windows
®
10 IoT Enterprise.
If you install any version of Microsoft
®
Office onto the
CAM computer, you will violate the Windows
®
License
Agreement which may result in the following:
n
You may lose the right to use the pre-installed
Windows
®
on the CAM computer. Without Win-
dows
®
, the machine will not work.
n
You may become subject to civil and criminal
prosecution.
Never
install any version of Microsoft
®
Office onto
the CAM computer.
Once the machine is connected to the CAD computer
and the network connection is established, the CAM
computer can be accessed in 3 ways:
Access method
Access to
CAM/CNC
folder?
Access to Win-
dows?
Remote Desktop applic-
ation on the CAD
computer
Yes Yes
Connecting hardware
to the machine
Yes Yes
Windows
®
Explorer on
the CAD computer
Yes No
n
Access via the Microsoft
®
Remote Desktop applic-
ation allows you to use Windows
®
/ DentalCAM
 DentalCNC on the CAM computer without
additional hardware.
n
You can connect additional hardware to access
the CAM computer to use Windows
®
/
DentalCAM  DentalCNC
n
Accessing the DentalCAM  DentalCNC install-
ation folder via Windows
®
Explorer is usually only
required for customer service.
If you do not use an integrated CAD/ CAM workflow,
you will need to access Windows
®
on the CAM
computer during standard operation to directly work
with DentalCAM  DentalCNC.
Original Operating Instructions:Z4
Version: 12/5/2018
Z4 – Installing the machine
EN 20