VHF Z4 - 2 General safety instructions; DANGER; WARNING

2 General safety
instructions
DANGER
Incorrect operation of the machine
Before
installing, maintaining and operating the
machine, read
all
documents provided with the
machine.
If it is unclear how to operate the machine in any
way, do not use the machine and contact cus-
tomer service.
Ensure that every user has access to the operating
instructions.
Instruct every user on safe and proper machine
handling.
Danger to life due to an electric shock
If you come into contact with electrically
charged parts, you can suffer from an elec-
trical shock. Water increases the risk signi-
ficantly.
Do not remove the housing of the machine.
Only have qualified electricians work on any elec-
tric equipment.
Ensure that an operational Residual Current
Device/ Ground Fault Circuit Interrupter is
installed on the electric circuit of the machine.
Run power cables so that they cannot be dam-
aged by sharp edges.
Before
switching on the machine, check power
cables for damage.
Before
unplugging the power cable, switch off
the machine at the main power switch.
In the following cases, disconnect the
machine from the electrical source imme-
diately and prevent it from being restarted:
n
When machine connections or electric cables are
damaged
n
When water is leaking
n
Before
you check or run electric cables
Replace damaged cables with original man-
ufacturers spare parts.
Never perform any troubleshooting while the
machine is operating.
Only have authorized service technicians repair
the machine.
Do not touch the machine and especially the
cables with wet or damp hands.
Check the environment of the machine and all
accessible internal areas daily for leaked liquid and
remove any liquids near or in the machine imme-
diately.
Never put any machines or devices which are
powered by electricity under the machine.
Do not put any objects onto the machine.
WARNING
Respiratory diseases when processing
harmful materials
If you inhale harmful materials during their processing,
your respiratory tracts may be damaged.
Avoid materials which damage your health.
Crushing hazard and risk of cutting injuries
through moving machine parts
Through the moving axes and the rotating spindle you
can suffer bruises and cuts.
Only use the machine when the working chamber
door is completely closed and undamaged during
machining.
Do not circumvent or deactivate safety devices of
the machine.
Check the machine regularly for damage, espe-
cially the safety devices.
Have damaged safety devices repaired by cus-
tomer service only.
Use only original manufacturer’s equipment and
original spare parts in the machine.
Keep children and animals away from the
machine.
Do not remove the housing of the machine.
Service Mode: Risk of cutting injuries and
bruises as well as hazards through ejected
debris
If you operate the machine in any “Service Mode”
with the working chamber door open, the risk of
injury is increased significantly.
Operate the machine in “User“mode only unless
you have been authorized by the machines man-
ufacturer to use other modes.
Even if you are an authorized user, use the “Ser-
vice Modes” only when necessary.
While in any “Service Mode”: Do not reach
into the working chamber while the axes are
Original Operating Instructions:Z4
Version: 12/5/2018
Z4 – General safety instructions
EN 6