EasyManuals Logo

virtual access GW2024P-2 User Manual

virtual access GW2024P-2
350 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #106 background imageLoading...
Page #106 background image
13: Configuring an Ethernet interface on a GW1000 router
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 106 of 350
option ifname 'eth0'
option monitored '0'
option ipaddr '2.2.2.2'
option netmask '255.255.255.0'
option gateway '2.2.2.10'
option broadcast '2.2.2.255'
list vlan_qos_map_ingress '1:2'
list vlan_qos_map_ingress '2:1'
config alias 'ethalias1'
option proto 'static'
option interface 'newinterface'
option ipaddr '10.10.10.1'
option netmask '255.255.255.0'
option gateway '10.10.10.10'
option bcast '10.10.10.255'
option dns '8.8.8.8'
root@VA_router:~# uci export firewall
package firewall
config zone
option name 'lan'
option input 'ACCEPT'
option output 'ACCEPT'
option network 'lan newinterface'
root@VA_router:~# uci export dhcp
package dhcp
……
config dhcp
option start '100'
option leasetime '12h'
option limit '150'
option interface 'newinterface'
To change any of the above values use uci set command.
13.4.2 Configuring ATM bridges
The ATM bridges section is not used when configuring an Ethernet interface on a
GW1000 router.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the virtual access GW2024P-2 and is the answer not in the manual?

virtual access GW2024P-2 Specifications

General IconGeneral
Brandvirtual access
ModelGW2024P-2
CategoryWireless Router
LanguageEnglish